Add: RM101&201, BLD. 3TH, No.2, lane 6th, Laokeng Ind. Zone, Kengzi, Pingshan New District, Shenzhen City, China
The knowledge of mold
1、The basic structure of the mold
(3) insert (insert) ﹑ (4) line position (slider), (5) rear mold (male mold) ﹑ (3) insert (insert) ) Slanting ﹑ (6) thimble ﹑ (7) gate (inlet)
2、 The effect of the shape of the mold on the article
Wall thickness, geometry, will affect the forming shrinkage, stripping slope size
3、The influence of the inlet on the shrinkage of the product
The size of the inlet is large, the shrinkage rate is small, the size is small, the shrinkage rate is large, the flow direction parallel to the shrinkage rate is large, the vertical direction is shrinking small
4、 Die wall thickness is too large, too thick wall thickness
Wall thickness is too large: (1) increase the cost (2) to extend the forming time, reduce production efficiency (3) difficult to control quality, prone to bubbles, shrinkage, depression, etc.
Wall thickness is too small: (1) plastic in the mold flow resistance. If the shape is more complex, forming will be difficult (2) the intensity is poor.
If the plastic parts of the wall thickness is not uniform, then the forming process will shrink uneven, not only caused by bubbles, depression, deformation, there will be a large internal stress. Wall thickness and wall at the junction to avoid an acute angle, excessive ribbon and thickness should be along the direction of plastic flow gradually reduced.
5、 Fillet (R bit)
Set the fillet (R bit) to increase the strength so that the plastic parts do not deform or crack
(1) In order to ensure the strength and rigidity of the product, and not to make the plastic wall thickness, the appropriate parts in the plastic parts to set the ribs to prevent deformation, in some cases, can also improve the plastic flow in the formation of the problem.
(2) the thickness of the ribs can not exceed 50% of plastic parts, usually about 20%
(3) stiffeners should be lower than the plane of the plastic parts （www.a-mold.com）
Related Industry Knowledge
- Injection molding machine
- Injection mold construction
- Plastic model
- Multi-material injection molding
- Liquid Injection Molding
- Hot runner
- What is the Plastics Industry?
- What is Mold?
- What's rapid injection molding
- How to increase the life of injecti...
- The Plastic Injection Molding System
- What should we pay attention to whe...
- Plastic injection mold design
- plastic injection mold Process trou...
- What is plastic injection mold
- what is Extrusion mold
- what are the benefits of injection ...
- The knowledge of mould
- Multi-material injection molding pr...